Casati CIM 3100 Veneer Guillotine
These machines are ideal for companies with a dedicated veneer department. The welded steel structure, made with special table section design ensuring high torsional rigidity. The knife-beam movement takes place between three sets of selflubricated slides. . The clamping-beam is equipped with torsion bar.
Pressure beam movement is by two hydraulic cylinders. The knife beam is driven by a geared motor.
Knife beam and clamping-beam: These are highly ribbed to ensure optimum stiffness.
Twin push-buttons on the control panel operate the pressure beam. Once the beam is down, the cutting operation takes place.
Rear fence: the rear fence is driven by means of a wheel placed on the front side of the machine. A digital counter allows you to measure the distance between the rear fence and the cutting line.
Angular fence: on the left side of the machine table, this allows easier alignment of the veneer.
Cutting line: a special plastic cutter counter gib with 4 cutting points.
Safety: Two hand control and anti-repeat devices.