Fine Dust Units PJDMV2.5-SM-I

Designed to extract waste from smaller fine dust emitting machinery, such as that produced from various sanders, linishers, grinders,
polishers and band saws etc.

Powerful - able to serve multiple point extraction simultaneously

Low height of 770mm, makes unit ideal to fit under work benches

Extremely compact size, recirculatory with high efficiency, low noise level and safety features make this unit particularly suitable for use in educational / training
environments and small workshops where space is at a premium

An integral face mounted viewable filter gauge ensures the user can see that your extraction unit is working
effectively to protect you from the hazardous substances controlled, enabling you to maintain the filter in good condition and advising when it needs to be cleaned or
replaced

Premium quality super-glazed filters provide an extra smooth surface offering unsurpassed particle collection efficiency and improved long-term performance. Other filter media available for specialist applications

Option for a H13 or H14 grade HEPA filter add-on for enhanced air filtration performance

Various inlet duct point options to sides or rear make connection practical, Ideal for standing flush to a rear wall for optimising space if the side inlet locations are utilised

For added convenience and flexibility in the smaller workshop there is an optional mobile kit available

Can be supplied with a reinforced top for use as a support base for small machines that it serves or as a workspace, this optional extra should be requested at the time of ordering

Option to be electrically interlocked to the equipment served (specify interlock starter / control panel when ordering)

PERFORMANCE
Designed to give a maximum airflow of 1900 m?/hr at the inlet, before allowing for the resistance of the ducting, please consult the fan curve to identify the
predicted airflow at the resistance pressure loss for your system duct layout.

NOISE LEVEL
Typically 79 dB(A) measured at 2 metres for average acoustic conditions
INLET Inlets diameters available: 63mm, 80mm, 100mm, 125mm & 150mm these can be installed on any combination of the four inlet points located 1 x left, 1 x
right and 2 x rear, however simultaneous extraction can only be provided for the combinations A to G below. If additional inlets are required shut off valves must be present on each duct run to close off inlets that exceed the maximum simultaneous extraction capability. If inlet diameter and quantity is not specified on your order it will be supplied with 1 x 150 mm as standard,

A) 1 x 150mm (STANDARD)
B) 1 x 125mm + 1 x 80mm or 63mm
C) 2 x 100mm D) 1 x 100mm + 2 x 80mm
E) 1 x 100mm + 3 x 63mm F) 3 x 80mm
G) 4 x 63mm

240V single Phase